b square scope mount
11-18-2004, 12:21 AM
#2
Nontypical Buck
Join Date: Feb 2003
Location: Spring Grove, Pa. USA
Posts: 2,120
RE: b square scope mount
I have one on my Benelli Nova( I assume the procedure will be the same).There's 2 pins you have to take out of the trigger assembly-right above the trigger on the receiver-then replace with the pins and bolts that came with the scope mount.Make sure you put the spacers between the receiver and the mount then secure with the bolts.
11-18-2004, 08:42 AM
#4
Nontypical Buck
Join Date: Feb 2003
Location: SW Michigan
Posts: 1,906
RE: b square scope mount
Each gun is a little different. If you cannot determine which bolts to remove, contact B-square directly.
Typically, you would remove the pin/bolt (it may be a panhead bolt---with a flathead screw slot) directly above the trigger assembly. The second B-square bolt may or may not go through your receiver. On my Ithaca, the second mounting pin actually goes below the receiver in front of the trigger, and stays secure via upward pressure.
If you can posts digital pics of each we can talk you through it easily...
Typically, you would remove the pin/bolt (it may be a panhead bolt---with a flathead screw slot) directly above the trigger assembly. The second B-square bolt may or may not go through your receiver. On my Ithaca, the second mounting pin actually goes below the receiver in front of the trigger, and stays secure via upward pressure.
If you can posts digital pics of each we can talk you through it easily...
