proper load?
#1
Thread Starter
Joined: Oct 2008
Posts: 16
Likes: 0
This is for all you reloader's out there
I am shooting a 7mm-08 for the first time and I am hand loading it. I am shooting 150 gr ballistic silvertips.
I finally found a load that grouped well with my rifle but i am only shooting 39gr of vihtovouri n150 powder. My concern is that this is a slow burning powder and I am just not sure it will have enough umphh for whitetails my shots will NEVER be over two hundred and likely 100 and probably most 75- 50 yds. The season is two weeks away and i have already loaded my hunting rounds. Is it going to give me enough energy with this particular load? I am guessing its leaving the barrel at 2400 fps. I taped some old glossy catalogs together 4.5 inches thick with a complete pass through at 100yds with good expansion. This is a quick expanding bullet that fragments easy as you may know so i don't think expansion will be the trouble. I am mildy concerned over the penetration though. Thoughts?
thanks trevor
I am shooting a 7mm-08 for the first time and I am hand loading it. I am shooting 150 gr ballistic silvertips.
I finally found a load that grouped well with my rifle but i am only shooting 39gr of vihtovouri n150 powder. My concern is that this is a slow burning powder and I am just not sure it will have enough umphh for whitetails my shots will NEVER be over two hundred and likely 100 and probably most 75- 50 yds. The season is two weeks away and i have already loaded my hunting rounds. Is it going to give me enough energy with this particular load? I am guessing its leaving the barrel at 2400 fps. I taped some old glossy catalogs together 4.5 inches thick with a complete pass through at 100yds with good expansion. This is a quick expanding bullet that fragments easy as you may know so i don't think expansion will be the trouble. I am mildy concerned over the penetration though. Thoughts?
thanks trevor
#2
I'm not familiar with vitovouri powder at all. If this is listed in that powder's manual and you are getting excellent accuracy-fret not. One thing about expanding bullets is generally the lower the velocity,the slower it will expand-thus increasing penetration to a degree. If you have a kinetic bullet puller such as the universal model rcbs makes,it wouldn't take very long at all to pull bullets,save powder,and recharge/reseat bulletsto an safe increased power loading after checking said load for accuracy,pressure,etc.




