300 WBY Mag Elk Load
#12
Thread Starter
Join Date: Jul 2005
Location:
Posts: 27
RE: 300 WBY Mag Elk Load
That's impressive. I may have another one to try now. I know they have a higher Ballistic Coefficient than a lot of other bullets, allowing better trajectory at long ranges, I just wasn't sure of firing a lead core bullet at an elk at3200+ FPS. I would like to try different bullets on deer to get a rough idea of expansion/penetration, but i'm not going to have a chance because this hunt is before the season.
#13
Giant Nontypical
Join Date: Feb 2003
Location: fort mcmurray alberta canada
Posts: 5,667
RE: 300 WBY Mag Elk Load
I just wasn't sure of firing a lead core bullet at an elk at3200+ FPS.
#14
Nontypical Buck
Join Date: Feb 2003
Location:
Posts: 3,516
RE: 300 WBY Mag Elk Load
Ka-Pow:
If you can get your hands on some Norma MRP, I would go with a 200 gr. Barnes X, Nosler Partition, Swift A-Frame, TBBC, or Winchester Fail-Safe. With Norma MRP it is possible to launch a 200 gr. projectile 3,150 f/s 4,406 ft/lb. Good luck.
If you can get your hands on some Norma MRP, I would go with a 200 gr. Barnes X, Nosler Partition, Swift A-Frame, TBBC, or Winchester Fail-Safe. With Norma MRP it is possible to launch a 200 gr. projectile 3,150 f/s 4,406 ft/lb. Good luck.
#16
Thread Starter
Join Date: Jul 2005
Location:
Posts: 27
RE: 300 WBY Mag Elk Load
I was just going to ask about Barrel fouling.
Thanks for the tip handloader, I would like to load bullets that will work well for deer and elk, so once my rifle is dialed in, i don't have to switch loads, and the hunt i'm going on is a Mule deer/elk hunt.
Stubblejumper: i wasn't saying that it isn't possible, and congratulations on your kills, i just thought the expansion would be too rapid.
Thanks for the tip handloader, I would like to load bullets that will work well for deer and elk, so once my rifle is dialed in, i don't have to switch loads, and the hunt i'm going on is a Mule deer/elk hunt.
Stubblejumper: i wasn't saying that it isn't possible, and congratulations on your kills, i just thought the expansion would be too rapid.
#17
Nontypical Buck
Join Date: Feb 2003
Location: Western Nebraska
Posts: 3,393
RE: 300 WBY Mag Elk Load
For the big game loads in .308 caliber I like the 200 grain A-Frames.
It's a lot of bullet and at speeds of over 2,800'/sec they shoot mighty flat and performance seems to be worth their cost.
It's a lot of bullet and at speeds of over 2,800'/sec they shoot mighty flat and performance seems to be worth their cost.
#18
Typical Buck
Join Date: Jun 2005
Posts: 604
RE: 300 WBY Mag Elk Load
You may want to give the 200 grain accubond a try it has a .588 BC and will buck the wind better than anything out there on long shots. You can always rangefind your distance but it is a guess as to wind drift. My buddy uses them from a 300RUM and it is his most accurate load.It is also worthmentioning the 200 grain bullet is a whole lot of whoop ass out of a wby mag.
#19
Join Date: Feb 2003
Location: Pennsylvania
Posts: 85
RE: 300 WBY Mag Elk Load
Nosler 180 grain Accubond
84.0 grains of IMR 7828
26 inch Barrel Mrk V Accumark with Brake
Fed 215 M Primer
load long enough to fit in gun magazine
Shoots 3/4 MOA out of box rifle
I have been working on a load for awhile and this one would bea nice choice for Elk.
I am however going to now work up a load for the Barnes Triple Shock in .30 cal 150 grain. That should be fast and flat!!
Good luck
Read the latest Nosler reloading manual for the load above.
This is hot load and works safe in my rifle with no signs of pressure. That does not mean it will work in yours. Please load safely and double check powder and grians with manual before using.
84.0 grains of IMR 7828
26 inch Barrel Mrk V Accumark with Brake
Fed 215 M Primer
load long enough to fit in gun magazine
Shoots 3/4 MOA out of box rifle
I have been working on a load for awhile and this one would bea nice choice for Elk.
I am however going to now work up a load for the Barnes Triple Shock in .30 cal 150 grain. That should be fast and flat!!
Good luck
Read the latest Nosler reloading manual for the load above.
This is hot load and works safe in my rifle with no signs of pressure. That does not mean it will work in yours. Please load safely and double check powder and grians with manual before using.
#20
Join Date: May 2004
Location:
Posts: 454
RE: 300 WBY Mag Elk Load
I load for a friends 300 Wby, and all he shoots is the Sierra 165 HPBT Gameking. Bullet has a proven track record with both of us and shoots really tight groups in his rifle. I shoot the 180 Barnes TSX in my 300 RUM and have tried to get him to switch, but he wants no part of it, so to each his own. Shoot what shoots best in YOUR rifle.