40 S&W in 10mm Revolver?
#2
Nontypical Buck
Joined: Jun 2004
Posts: 2,051
Likes: 0
From: NW Ohio , 5 min from Ottawa National / Magee Marsh
IMO if the gun uses moon clips it would work .
I would call the gun maker and ask.
If they say ok ,make sure that you clean the chambers so that the 10mm ammo would chamber .
If the cases head space on the case mouth then NO
I would call the gun maker and ask.
If they say ok ,make sure that you clean the chambers so that the 10mm ammo would chamber .
If the cases head space on the case mouth then NO
#3
Since it's a rimless cartridge I would say no. It headspaces on the mouth of the case.Like mentioned if it uses half or full moon clips it would work fine.
Ruger Redhawk
Ruger Redhawk
#4
Joined: Jan 2005
Posts: 2
Likes: 0
From:
Yes, you can as long as you use moonclips.
I have run some .40's through my 610's.
There is a very good 10mm site at www.10mmtalk.com. You should drop in.
I have run some .40's through my 610's.
There is a very good 10mm site at www.10mmtalk.com. You should drop in.
#5
In the 610 you absolutely can shoot either just as you can shoot 38 shells in a 357 mag. I have had two 610 revolvers They use moon clips and one of mine shot much better with the 40 S&W than the 10 MM. They are the most accurate revolver that I ever laid hands on.




