Building a new 300 RUM
12-02-2004 | 05:24 PM
#13
Guest
Posts: n/a
RE: Building a new 300 RUM
bigcountry, you stated that you would also recrown. Why? Like I said, with a quality stock, scope, receiver and trigger already in my possession, I am hoping to get away with this for as little as possible, so going out and spending 200 - 300 dollars on a barrel is kind of defeating the purpose.
12-02-2004 | 05:53 PM
#15
Giant Nontypical
Joined: Feb 2003
Posts: 5,667
Likes: 0
From: fort mcmurray alberta canada
RE: Building a new 300 RUM
do you guys have hats and jackets and walk around in a gang??
As for the ultramag conversion,three rounds will not fit the non ultramag magazine.The ultramag case will not feed properly without modifying the rails.Be advised that if you remove too much material it will not feed properly either.I suggest that you have a gunsmith that has done this before, do the feed rail work.I believe that you also require the ultramag follower.The bolt face will be fineas is.I am aware of these things because one of my ultramags was built on a standard magnum action.
