How many of us use a folding table for processing deer?
10-16-2007 | 03:12 PM
#1
Thread Starter
Typical Buck
Joined: Sep 2006
Posts: 561
Likes: 0
From: Col. Oh.
How many of us use a folding table for processing deer?
If you do; here is a tip. Take a 4x4 post and cut it into 4 -12" pieces. Drill a 1"diameter hole in the end of each one. Use the posts to raise your table. this way your back doesn't hurt when you're done.
[/align]
10-16-2007 | 03:16 PM
#2
Boone & Crockett
Joined: Oct 1998
Posts: 18,322
Likes: 0
From: Hughesville, PA USA
RE: How many of us use a folding table for processing deer?
Excellent tip. I'll think of that if necessary...I use a piece of plywood atop my barrel that I discard bones etc..into...
Another tip I've picked up during outdoor shows, maybe even cheaper, instead of 4 x 4 posts, get a piece of drain pipe, preferably 2" and that will hold the legs of a folding table too to raise it up.
Another tip I've picked up during outdoor shows, maybe even cheaper, instead of 4 x 4 posts, get a piece of drain pipe, preferably 2" and that will hold the legs of a folding table too to raise it up.
Thread
Thread Starter
Forum
Replies
Last Post
deermasters
Hunting Gear
0
03-11-2007 05:02 PM
