Need 1" Scope rings Weaver HI and Med rise
01-18-2008 | 10:21 PM
#1
Thread Starter
Joined: Dec 2006
Posts: 145
Likes: 0
From: Dearborn County Indiana
Need 1" Scope rings Weaver HI and Med rise
I just got a new gun (yeaaaaa for me ) I need to put a scope on it but the scope is to low what I need are one of each a med and a hi rise 1" scope weaver rings. This is for a shotgun HR ultra sluger the hammer is hitting the scope bad so I need to get a higher rings. Any help would be great Let me know what you have and I buy it - Thanks -
01-19-2008 | 12:19 PM
#2
Typical Buck
Joined: Feb 2004
Posts: 809
Likes: 0
From:
RE: Need 1" Scope rings Weaver HI and Med rise
01-19-2008 | 09:40 PM
#4
Joined: Apr 2007
Posts: 321
Likes: 0
RE: Need 1" Scope rings Weaver HI and Med rise
Maybe I am not reading this right, but if I am - I can tell you that you cannot mix and match scope mounts.
You either have to use mid mounts or you have to use high mounts.
You cannot use one mid mount and one high mount on the same scope.
The scope has to be mounted parrallel to the bore of the rifle.
If it is canted up or down, the gun is never going to be accurate at any distance.
You either have to use mid mounts or you have to use high mounts.
You cannot use one mid mount and one high mount on the same scope.
The scope has to be mounted parrallel to the bore of the rifle.
If it is canted up or down, the gun is never going to be accurate at any distance.
01-20-2008 | 11:40 AM
#5
Thread Starter
Joined: Dec 2006
Posts: 145
Likes: 0
From: Dearborn County Indiana
RE: Need 1" Scope rings Weaver HI and Med rise
I am asking for both sets so I can see if one height is better than the other. I know very well you can't mix match the height. I lap my scope rings once they are set. To make sure there is a even grip on them.
