insert question
03-04-2008 | 02:40 PM
#1
Thread Starter
Joined: Feb 2007
Posts: 27
Likes: 0
insert question
what kind of glue are you all using to glue in your inserts i just started cutting and fletching my own arrows and i used quickspin glue and had 3 inserts pull out onme target shooting the other day , your help is much appreiciated
03-04-2008 | 09:11 PM
#4
Nontypical Buck
Joined: Feb 2003
Posts: 3,625
Likes: 0
From: Middletown PA United States
RE: insert question
Yepper, 24 HR epoxy for sure, but only after you clean the inside of the shaft where the insert goes. It could be that the glue you are using can't get a bond to the inner surface of the shaft due to carbon dust
03-05-2008 | 09:19 AM
#6
Joined: Sep 2005
Posts: 265
Likes: 0
From:
RE: insert question
don't use hot melt on carbon.
clean the inside of your shaft with denatured alcohol before you glue the insert in, then just use super glue gel. I use it and have never had one pull out (well, one that wasn't cracked at least).
Do not use gorilla glue, it expands as it dries and could cause your carbon to bust easily.
clean the inside of your shaft with denatured alcohol before you glue the insert in, then just use super glue gel. I use it and have never had one pull out (well, one that wasn't cracked at least).
Do not use gorilla glue, it expands as it dries and could cause your carbon to bust easily.
