Well here it is. About $3.00 in materialsand 30 minutes of assembly. 2 furring strips and some scrap wood nailed together for a pretty decent 24"x24"paper holder for paper tuning.

I builtmine short because I have a set of steps Isetit upon, but you can make yours taller to suit your setup. I use a fewthumb tacks to hold the paper on. Good luck building yours! [&:]

I just use a big wood clamp and a refigerator magnet clip on the bottom of the paper. Then I hang it from a rafter in my garage.

I have also done it with a cardboard box with a hole cut in it.

Paul

I have also done the box with a hole in it.

i built one similar to that last year. i put it on top of the picnic table and shot into a foam target thati made at work. very low cost, and good results... good job bud!

thanks for sharing the ideas!

How about simply using a doorjam, some paper, and tape?

Good luck hunting! >>>------------>