peep sight
#1
hey guys i just picked up my bow today to shoot around a little bit and practice..but i noticed when i draw my bow back my string is lined up right in the middle of my peep sight..can anyone tell me how to fix this??
#2
Normally when you pick up a new bow,you will have to shoot it 50-100 times to break the string in.Then re-install the peep and it shouldent give you any hassles.
Try twisting the string and tighten up the serving holding the peep in place,sometimes this works.
Try twisting the string and tighten up the serving holding the peep in place,sometimes this works.
#3
I'm assuming you have a peep that splits the string in 3 strands...not a big fan...shoot it for a while, break the string in and see where it leaves you...
If that fails, in a press, slack the string and move a couple strands from each split on the peep in the same direction, this will rotate your peep....
If that fails, in a press, slack the string and move a couple strands from each split on the peep in the same direction, this will rotate your peep....
#4
Yep, same as Rob... Save yourself the years of hassle I went through and use my experience as your wisdom; ditch the shurz-a-peep with three strands and go get a fletcher-style which only hasone strandrunning on each side. A literal WORLD of difference!
#5
Joined: Feb 2003
Posts: 699
Likes: 0
From: Wilmington Delaware USA
I always had the same problem. I ended up getting rid of the peep and just shot without it. The only difference was I used a second anchor point (string touching the tip of my nose). I had to make a slight sight adjustment and I was good to go. Its so nice to have a clear line of vision to my pins.
Good luck on whatever you choose to do!
Good luck on whatever you choose to do!

Thread
Thread Starter
Forum
Replies
Last Post
CharlieNY
Archery Gear
2
10-17-2006 01:16 PM




