reloading the 6.8 SPC
02-21-2008 | 10:30 PM
#1
Thread Starter
Joined: May 2007
Posts: 177
Likes: 0
From:
reloading the 6.8 SPC
Just wondering if anyone here has reloaded the 6.8 SPC or the 6.5 Grendel in the past....
what was the overall cost per cartridge? were you able to produce them cheaper than factory loads?
Ive seen all kinds of casings, bullet types and weights and a few different kinds of powder. From what Ive heard, Hornady uses a mixture of two seperate powders into their 6.8 SPC. Has anyone been able to successfully replicate an equivilant to their 6.8 TAP?
what was the overall cost per cartridge? were you able to produce them cheaper than factory loads?
Ive seen all kinds of casings, bullet types and weights and a few different kinds of powder. From what Ive heard, Hornady uses a mixture of two seperate powders into their 6.8 SPC. Has anyone been able to successfully replicate an equivilant to their 6.8 TAP?
