IM SO EXCITED!!

Reply Subscribe

Thread Tools

07-21-2007, 10:31 AM

#11

lethalconnection

Thread Starter

Join Date: Dec 2005

Location: Calgary,Alberta,Canada

Posts: 2,123

RE: IM SO EXCITED!!

Quote:

ORIGINAL: Phil from Maine

Good job Lethal, I am sorry to here about your boat leaking.. Normally silicone works great.. Have you tried the alluminum welding rods? They can be melted with a normal propane torch and should seal the leak fine..

Problem is my boat is fibreglass and wood, if it was an aluminum boat i would have done that already since i weld for a living, but im thinkin im gunna get a round piece of rubber drill a hole the exact size of the cord but a lil bit bigger then the hole thats in the boat, put silicone around it and hammer it in then cover it all with silicone again.

07-21-2007, 10:52 AM

#12

Phil from Maine

Boone & Crockett

Join Date: Feb 2006

Location: Maine

Posts: 12,568

RE: IM SO EXCITED!!

I would drill it out a little bit bigger than the crack, and make sure you get all the carck and put a little cloth in it, then a coat of fiberglass over it. Good Luck to you on this project..