MJR10

When I draw the legacy all the way back there is no solid stop when I reach full draw. I have drawn a PSE and a Patriot back and when you come to full draw there is a solid stop due to a peg that is screwed into the cam. Does Mathews make this for the cam on the legacy?

gutshot

MJR: You may want to check the draw length on the Legacy the you drew because my Legacy comes to a dead stop. It sounds like the one that you drew was to long.

b-rice

Take it back because mine stops

Buckbuster4ou

Either the draw length of the bow is to much for you or there is something wrong
with the bow. My Legacy has a nice solid stop.

kodiakhuntmaster

My darton has no real solid stop. Something about the way older models of dartons were made to draw.

ijimmy

The no valley cam . Its why I sold mine .

archerick

The legacy cam does stop. My quess is your draw length was measured wrong. You aren' t getting to the wall because the draw length on your bow is too long. In my experience, I have noticed that most shooters are shooting bows with draw length that are too long. Go to a good pro shop and have them measure your wing span and set your draw lengnth from that. I left my wing span chart at the shop or I would list it. I' m sure someone here has it, if not I list it tonight for you.

MJR10

Thanks for the help. It was a draw length problem. I eliminated the string loop and shortened my release. The legacy has never felt more comfortable. Thanks again.