Legacy question
 

When I draw the legacy all the way back there is no solid stop when I reach full draw. I have drawn a PSE and a Patriot back and when you come to full draw there is a solid stop due to a peg that is screwed into the cam. Does Mathews make this for the cam on the legacy?

RE: Legacy question
 

MJR: You may want to check the draw length on the Legacy the you drew because my Legacy comes to a dead stop. It sounds like the one that you drew was to long.

RE: Legacy question
 

Take it back because mine stops

RE: Legacy question
 

Either the draw length of the bow is to much for you or there is something wrong
with the bow. My Legacy has a nice solid stop.

RE: Legacy question
 

My darton has no real solid stop. Something about the way older models of dartons were made to draw.

RE: Legacy question
 

The no valley cam . Its why I sold mine .

RE: Legacy question
 

The legacy cam does stop. My quess is your draw length was measured wrong. You aren' t getting to the wall because the draw length on your bow is too long. In my experience, I have noticed that most shooters are shooting bows with draw length that are too long. Go to a good pro shop and have them measure your wing span and set your draw lengnth from that. I left my wing span chart at the shop or I would list it. I' m sure someone here has it, if not I list it tonight for you.

RE: Legacy question
 

Thanks for the help. It was a draw length problem. I eliminated the string loop and shortened my release. The legacy has never felt more comfortable. Thanks again.