neb

I bought a used outback and I noticed on the cam where you can change the draw lenght from 29 to 291/2 the bolt with the rubber spacer that the bolt doesn't come out flush on the other side of the cam. I would say it is inside about 3/16 of an inch. Is this normal or should I get it checked out. If you can help I would appreciate it very much

mobow

When in doubt, check it out.

whitetailsoldier

get it checked, It could have been like that for years but it should be rapaired

gutshot

You can't change the draw length on a Mathews Outback without completely changing the cam.The Outback dosen't offer adjustable draw length.

TeeJay

Yes it does, but you go from 65% let off to 80%.

killzonearchery

get it checked becuase it could mess up the cam worst if you dont.

neb

Thanks for the help and I did get it checked and there is know problem with it it's the way it should be. Yes you can change the draw lenght by 1/2 inch on the outback which is a nice feature for the bow. Thanks for your help and reply's.