bows
#12
Join Date: Dec 2004
Location: Lititz, Pa.
Posts: 175
RE: bows
rockfish, why dont you post that websight and try to get people to join get it going like this websight i would but for some reason my computer wont let me
as for the epoxy rests, I've always used plumbers putty to do mine... this is a 2 part epoxy, that'll allow about 10 minutes of fooling around to adjust your center shot... the way it looks, we're both getting about the same results... I went back and readjusted this one after it had set up but it still works fine...
#13
Join Date: Dec 2004
Location: Lititz, Pa.
Posts: 175
RE: bows
when you build these epoxy rests, you want to leave a high point in the center of the rest to allow only minimal contact with the arrow... I use a rat tail file to work this up after the epoxy dries, that's why I had to add to this rest because I screwed up the first time around...
#14
Nontypical Buck
Join Date: Feb 2003
Location: auburn new york USA
Posts: 2,050
RE: bows
rochfish i mean have a post with that websight, it will help get the web sight started like this one (hunting.net) i would but for some reason i can only "fst reply" i can post[:@] computer problems
#15
Join Date: Dec 2004
Location: Lititz, Pa.
Posts: 175
RE: bows
excuse me, but my "ole timers" is acting up again... had to reread your post again to finally figure out what you were saying... I'm gonna have to start drinking again so I have an excuse for being so dense sometimes...
#17
Join Date: Dec 2004
Location: Lititz, Pa.
Posts: 175
RE: bows
ORIGINAL: Allseasonhunter7
rockfish, why dont you post that websight and try to get people to join get it going like this websight i would but for some reason my computer wont let me
rockfish, why dont you post that websight and try to get people to join get it going like this websight i would but for some reason my computer wont let me
[link]http://www.bowfishingsociety.com/[/link]
Thread
Thread Starter
Forum
Replies
Last Post
BowBuilder
Bowhunting
20
06-14-2006 10:11 AM