Community
Black Powder Ask opinions of other hunters on new technology, gear, and the methods of blackpowder hunting.

cvx wolf sight in

Thread Tools
 
Old 11-19-2010 | 05:45 PM
  #1  
Thread Starter
Spike
 
Joined: Feb 2003
Posts: 54
Likes: 0
From: minnesota USA
Default cvx wolf sight in

What way do you move the sight go up or down where should I be hitting at 100yds. my longest shot might be 200yds. say if i am in the bullseye at 100yds would i be at 200 150.
stcspiderman is offline  
Reply
Old 11-19-2010 | 06:04 PM
  #2  
Banned
 
Joined: Dec 2008
Posts: 9,186
Likes: 0
From: Boncarbo,Colorado
Default

Open sights,you move the sights in the direction that you need to go.

where the bullet impacts at 150-200 Depends on the load you are using.
MountainDevil54 is offline  
Reply
Old 11-19-2010 | 06:39 PM
  #3  
cayugad's Avatar
Dominant Buck
 
Joined: Feb 2003
Posts: 21,193
Likes: 0
From: Wisconsin
Default

You move the REAR sight the direction you want the bullet to travel. So if your hitting to the left and want your group to move to the right, move the rear sight to the right. If you're hitting low and want to move the POI up, move the rear sight up the ramp.
cayugad is offline  
Reply
Old 11-19-2010 | 11:45 PM
  #4  
Roger46982's Avatar
Typical Buck
 
Joined: Feb 2003
Posts: 667
Likes: 0
From: Indiana
Default

Don't know about you but with my old eyes or when I was younger for that matter, I would be lucky to even hit a deer with open sights at 200 yds.
Roger46982 is offline  
Reply
Old 11-20-2010 | 06:31 AM
  #5  
SuperKirby's Avatar
Nontypical Buck
 
Joined: Mar 2008
Posts: 1,068
Likes: 0
From: MN
Default

Totally off topic, but you don't happen to know stc superman do you? I haven't seen him for awhile.
SuperKirby is offline  
Reply
Old 11-21-2010 | 05:50 PM
  #6  
Thread Starter
Spike
 
Joined: Feb 2003
Posts: 54
Likes: 0
From: minnesota USA
Default

OK I like to know, is the gun I have messed up.

I am shooting the power belts with two 777 50 grain equal 100.


I have CVA wolf 2010 model, I shoot at 25yds get 2 shots in bull’s eye so I move out 50yds shoot nowhere on paper. 8x11 paper
why is this what could be wrong
stcspiderman is offline  
Reply
Old 11-21-2010 | 06:57 PM
  #7  
Banned
 
Joined: Dec 2008
Posts: 9,186
Likes: 0
From: Boncarbo,Colorado
Default

could be over shooting
MountainDevil54 is offline  
Reply
Old 11-21-2010 | 09:24 PM
  #8  
Thread Starter
Spike
 
Joined: Feb 2003
Posts: 54
Likes: 0
From: minnesota USA
Default

over shooting, What do you mean by this?
stcspiderman is offline  
Reply
Old 11-21-2010 | 09:50 PM
  #9  
Banned
 
Joined: Dec 2008
Posts: 9,186
Likes: 0
From: Boncarbo,Colorado
Default

when i sighted in at 25 yards, dead on, i pulled back to 50 yards only to find out that i was shooting 7" high.

Try a bigger target so you can figure out where your shots are impacting.
MountainDevil54 is offline  
Reply
Old 11-22-2010 | 04:32 AM
  #10  
Nontypical Buck
 
Joined: Mar 2004
Posts: 2,445
Likes: 0
Default

Most people see good accuracy with powerbelts, but some have seen bad performance on deer with 100 gr loads and close shots.
UncleNorby is offline  
Reply


Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.