What is used to remove the breech plug from the Knight Wolverine?
Thanks,
Bill

Assuming your using the hex head breech plug,
This: http://www.knightrifles.com/productDetail.aspx?id=326403

You can also use a socket but with the plunger guns it's more hassle than it's worth. The tool is better. It's the way they're designed. They have a finger which holds the plunger open till you pull the trigger. With the tool it's all 1 piece.



If your not then you need the 2ended version: http://www.knightrifles.com/productDetail.aspx?id=326401

The bad thing about this tool isthat it's for #11 nipples only. You'd need yet another tool fora musket nipple.

Thank you!! I'll need the second tool (two piece) as I have a slotted breech plug.

Kinda pricey!!
Bill

If this is the older model with a #11 nipple then a slotted breech plug, I use my CVA Staghorn breech plug removel tool. Even though I bought my Wolverine new, it never came with a breech plug removel tool.

http://www.midwayusa.com/eproductpage.exe/showproduct?saleitemid=396255

I think a person could make one out of some bar stock if they had a machine shop around them. There really is not too much too it. I like the CVA because it is much longer and I can by pass the scope with the longer one.

Your right, the old CVA tool would work best. I had fogotten about it. I remember mine would work with both #11 and Musket cap nipples.

http://www.cva.com/docs/cva_catalog_2006.pdf Looks like part AC1603 for 12.95

Download the catalog, there's ordering info in the back.

Many thanks to you all. I found one on the web for $10.00.
Bill