I need the BC for the Shock Waves and for the 10mm 200gr 40cal XTP
Could some one help me please. Lee

lemoyne


Here you go - this for the SST which is the same other than the sabot as the Shockwave.....





45 CAL SABOT WITH 40 CAL 200 GR SST/ML BULLET
[align=right]67132[/align]





Diameter
Weight
Ballistics Coefficient
Sectional Density

.400"
200 gr.
0.265
0.179

You can check it out here....

https://www.hornady.com/shop/

I shot some 10mm 200 grain XTP's this morning from one of my Remingtons. One of the last things I did was to shoot some quartzite rocks resting on some stumps... I shot both 250 grain Speers and 200 grain XTP's (BC of .199). The way they broke the rocks they certainlt will break shoulder bones no problem...

Thanks Sabotloader,is the 250 SW about the same? Lee

LEE

I wouldn't think so because the length/Diameter ratio will change the 45 caliber ballistics quicky - usually for the negative.

Here is the information from Hornady... It really isn't that good only slightly better than the Speer 250 grain Gold Dot (BC .199)and less than the 300 (BC .232)grain Gold Dot.

SST .452 - 250 grain BC .210 ( I really thought it would be higher)

50 CAL SABOT WITH 45 CAL 250 GR SST/ML BULLET

Diameter
Weight
Ballistics Coefficient
Sectional Density

.452"
250 gr.
0.210
0.175

XTP .452 - 250 grain

45 Cal. HP-XTP

Diameter
Weight
Ballistics Coefficient
Sectional Density

.452"
250 gr.
0.146
0.175


hope this helps and does not confuse the issue......

Thanks Sabotloader,I have some of the new bonded Shock Waves, after my Boar hunt in May I think I might do a bit of experementing myself.
Right now I am trying to get sighted in but we have had two friends died and one realative is going to so its been hard to get away to the range, I am tryingbetween trips. Lee