HOMEBREW S600 Question
#1
HOMEBREW S600 Question
When you get done with the kit how do you take the goop off of the lens on the outside of the camera?/??????
Just needing to know the best way without scratching the lens
thanks
Just needing to know the best way without scratching the lens
thanks
#2
RE: HOMEBREW S600 Question
You are talking about the glass you gooped to the camo case correct (I hope) ?
I use a sharp carpenters knife and cut around the hole being careful not topenetrate / ruin the glass.
Then use the back side of the blade to peel up part of the goop so you can grabe the excess goop with a pair of needle nose pliers and pull it off.
Wait at least 24 hours before doing this and it will come off as one piece as long as you have cut all the way through it with the knife.
If you bought the kit from Whitetail Supply you shold check out his item thatsused to mount the glass.
I cant think of what they are called but they are made out of the double sided (auotmotivetype) tape, the same thing that is used in his kit to mount the fresnel lens.
It takes just a few seconds to mount the roundglassand no goop mess.
I use a sharp carpenters knife and cut around the hole being careful not topenetrate / ruin the glass.
Then use the back side of the blade to peel up part of the goop so you can grabe the excess goop with a pair of needle nose pliers and pull it off.
Wait at least 24 hours before doing this and it will come off as one piece as long as you have cut all the way through it with the knife.
If you bought the kit from Whitetail Supply you shold check out his item thatsused to mount the glass.
I cant think of what they are called but they are made out of the double sided (auotmotivetype) tape, the same thing that is used in his kit to mount the fresnel lens.
It takes just a few seconds to mount the roundglassand no goop mess.