Warf Project
03-19-2008 | 06:15 AM
#21
Dominant Buck
Joined: Feb 2003
Posts: 26,274
Likes: 0
From: land of the Lilliputians, In the state of insanity
RE: Warf Project
This site might help you with the lam delima.
http://www.stickbow.com/FEATURES/BOWBUILDING/startbuilding.CFM
http://www.stickbow.com/FEATURES/BOWBUILDING/startbuilding.CFM
03-19-2008 | 03:54 PM
#22
Nontypical Buck
Joined: Feb 2003
Posts: 1,269
Likes: 0
From: Blanchester Ohio USA
RE: Warf Project
ORIGINAL: Redneck Bowhunter
So, you didn't use any fiberglass in your limbs it is just wood? And how did you glue it all up with that tapered peice in there?
So, you didn't use any fiberglass in your limbs it is just wood? And how did you glue it all up with that tapered peice in there?
If it were me I'd try gluing up the limb up to where the tapered block would be. Stop the fiberglass there (see pic) Then once thats dry glue on the block and shape as needed.
Or you could make your form to glue it all together all at once.
03-22-2008 | 03:22 PM
#24
Thread Starter
Joined: Jun 2007
Posts: 1,020
Likes: 0
From:
RE: Warf Project
Well, after putting a lot of thought into this, I have decided to put this project on the back burner for a little bit. I have decided to try and make a recurve bow with a Bingham project plan first. Then after I have that experience, I will try making the limbs for my riser.
03-25-2008 | 07:17 AM
#25
Dominant Buck
Joined: Feb 2003
Posts: 26,274
Likes: 0
From: land of the Lilliputians, In the state of insanity
RE: Warf Project
ORIGINAL: Redneck Bowhunter
Well, after putting a lot of thought into this, I have decided to put this project on the back burner for a little bit. I have decided to try and make a recurve bow with a Bingham project plan first. Then after I have that experience, I will try making the limbs for my riser.
Well, after putting a lot of thought into this, I have decided to put this project on the back burner for a little bit. I have decided to try and make a recurve bow with a Bingham project plan first. Then after I have that experience, I will try making the limbs for my riser.
