ata on one side is just right, measuring from the center of the post with the e-clip. on the other side it's about 3/32 long. when i took the slide off just to observe it helped, but still not completely equal. how do i fix this? it didn't seem like twisting the split would be the answer so i thought i better ask. should i fix it? it shoots fine ( as far as i can tell). any help would be appreciated.

gibblet

I believe the onlyy way that you fix the problem is to shorten the LONGER side by either
twisting it or have a new Buss Cable applied. If that side of your yolk is that much longer, then it is also causing your idler cam to cant slightly, which would in turn cause premature string wear

JMO AL

If that's the case you should be able to look down the string from behind the cam and see that the string does not come out of the cam straight. To fix this, twist up the long side of the yoke.

--Bob

thanks guys.

uh, duh, went to measure again and figured out my tape was arching over the cable -guard and creating the xtra. wow i feel smart.

LOL gibblet

Good thing you didn't make any adjustments!

That's why we're told to Meassure twice and Cut once

AL