Anyone installed a MZE on a bow with 8" brace height?
06-13-2003 | 08:08 PM
#1
Thread Starter
Spike
Joined: Feb 2003
Posts: 96
Likes: 0
From: Fancy Gap VA USA
Anyone installed a MZE on a bow with 8" brace height?
Have any of you guys installed a Muzzy Zero Effect on a bow with an 8" brace height? I' m trying to set mine up on a Mathews Rival Pro. If so, can you tell me which hole that the bolt goes through on the pivot arm and which hole the arrow rest itself goes through. I have the overdraw plate mounted against the riser (not touching). I tried calling Muzzy all day but got a busy signal every time. Any help would be appreciated.
06-14-2003 | 04:10 AM
#2
Fork Horn
Joined: Feb 2003
Posts: 333
Likes: 0
RE: Anyone installed a MZE on a bow with 8" brace height?
VA,
My MQ1 has a brace heighht of 7 1/4" , and my MZE is on the rear hole in the arm, closest to you when shooting the bow. I called Muzzy when I installed mine, and they told me to do this. They said that the Mathews have less cable travel, so the written instructions of brace height vs. which hole, didn' t apply to Mathews. Using this hole will give the longest measurement on the adjustment screw, so if you need to try another hole, it won' t be too short for them. I hope this helps you out some.
Charlie
My MQ1 has a brace heighht of 7 1/4" , and my MZE is on the rear hole in the arm, closest to you when shooting the bow. I called Muzzy when I installed mine, and they told me to do this. They said that the Mathews have less cable travel, so the written instructions of brace height vs. which hole, didn' t apply to Mathews. Using this hole will give the longest measurement on the adjustment screw, so if you need to try another hole, it won' t be too short for them. I hope this helps you out some.
Charlie
