RE: QAD tune up...
 

And based on whats happening with it.... seriously try that trick that I mentioned for the Hunter model... heck moving the whole rest forward in the berger hole a 1/4" or so might just do it... worth a shot anyway.

RE: QAD tune up...
 

can't move it any further forward, tried that too..;)

RE: QAD tune up...
 

One question.When you thumb the arrow up in the fork, do you should see the forks not be at 90degree angle pointing straight up. Do you see this? Then at full draw, you should see the rest go to 90degrees stright up. Do you see this? If you do, all you need to do now is make it go 90degrees up closer to full draw.

I guess what I am saying is, its essential that you understand what to look for.

RE: QAD tune up...
 

right, i have and it does with the thumb, as well as at draw. something else has to be going on....

RE: QAD tune up...
 

So I took the QAD Rest off my bow to check it out.

needless to say, it will not drop all the way. just holding it in my hand, goes from 90 degrees, to about 5, not 0. that explains that.

emailed QAD and am sending it in to them.

I put a NAP Quicktune "flipper" on in the mean while, a borrowed one from a friend of mine, looks kinda neat.
thanks guys

RE: QAD tune up...
 

Did it go to 0degrees on the bow? Did it have enough clearance from the shelf to go 0 degrees on the bow? Probably wont in your hand.

RE: QAD tune up...
 

I mounted it to a piece of wood so that I could measure it once I got it off the bow, it didn't drop to 0, there was a time that it did on my bow..... something failed in it, QAD said they would handle it, so no worries.

RE: QAD tune up...
 

Probably a weak spring or something like that.

I'll bet it good to know you aren't really going crazy after all :D Glad you found an answer!

RE: QAD tune up...
 

you have no idea....

RE: QAD tune up...
 

Hate to tell ya, but 5degrees is nothing. If it was 20degrees, that could pose a problem. But if its only 5degrees and you have clearance issues, you need to raise your nocking point until there is not clearance issue, and then at least paper tune. You probably know you cant paper tune with clearance issues. This is also another reason I hate bohning fletch. .5" high fletch is too high and not needed IMO.