RE: New " Non-Pink" Crest
 

On some of the larger diameter aluminums and larger carbons there is no overlap. On the Beman ICS 340s I use I just overlap them slightly. I suppose you could cut them, but that is too much like work for my tastes. that is also why I offset the logos slightly, it accounts for the overlap.

RE: New " Non-Pink" Crest
 

Now for a stupid Question. Once you have applied the crest wrap to the arrow how do you remove the wraps, if you want to change them etc?[&:]

RE: New " Non-Pink" Crest
 

There is no stupid question. There are several methods to getting them off. One is just good old fashioned elbow grease and a dull knife. I use acetone and a rag. The acetone does a great job eating through the paper and getting off the wrap.

RE: New " Non-Pink" Crest
 

reylamb; Thanks for the info;)

RE: New " Non-Pink" Crest
 

Since I have had quite a few requests I will send out these templetes to any one interested. They will be in Microsoft word, 6 on a page - Just print them out.

RE: New " Non-Pink" Crest
 

Hey rack, if you don' t mind, can you send one my way. That way I have a clue on what size to make these things.

Thanks

Send it here [email protected]

RE: New " Non-Pink" Crest
 

Looks great! how about sending template to [email protected] I understand you correctly they come 6 to a sheet and you don' t have to cut them out.

Thanks,
CB

RE: New " Non-Pink" Crest
 

You will have to cut them out. If you want them to fit without overlapping you will have to cut them down farther, depending on the arrow. I dont worry about the overlap on my carbons so I do not cut them down to the exact length. To cut them out I use a straight edge and a knife. It is quicker and easier than scissors.

RE: New " Non-Pink" Crest
 

I' d like the template please.

[email protected]

RE: New " Non-Pink" Crest
 

Nice job rack, I take it that the photo shop is a program right? If it is What store and how much$$ , if you dont mind me asking:eek:.........thanx fishon