Ontarget2 Run
#1
Guest
Posts: n/a
Ontarget2 Run
someone with ontarget, care to run some numbers for me?
Bow I am running this for is
Bowtech commander 70#
37" ATA
7.5" BH
29.5" draw
Only thing on the string is the loop and G5 peep
Arrows, I am looking at is Carbontech whitetail XP 65/80 at 30" with 125gr-150gr head. let me know if its too stiff
Bow I am running this for is
Bowtech commander 70#
37" ATA
7.5" BH
29.5" draw
Only thing on the string is the loop and G5 peep
Arrows, I am looking at is Carbontech whitetail XP 65/80 at 30" with 125gr-150gr head. let me know if its too stiff
#2
RE: Ontarget2 Run
I left it at 4 feathers and it comes out to an "optimal" spine of .3067. That is also with "hunting" selected which will give you a little stiffer spine in the optimal range than "target". FOC is 12.73
You can probably use them with no problem. I made the shaft a .5" longer (30.5) and it brought the spine down to .3017
You can probably use them with no problem. I made the shaft a .5" longer (30.5) and it brought the spine down to .3017
#4
RE: Ontarget2 Run
I had a 125gr head with a 15 gr insert. Although a CT insert for the whitetail will weigh 22 gr. I suppose I should have left the insert at 22 but was think a standard insert. So, anyway, with the CT insert that would bring the spine even closer to .300 and you could probably get away with a 30" shaft.
With the speed of the Commander you really don't need to increase the tip weight all that much past 125 but if you wanted to fool around with a higher FOC and shorter shaft...........
With the speed of the Commander you really don't need to increase the tip weight all that much past 125 but if you wanted to fool around with a higher FOC and shorter shaft...........
#5
RE: Ontarget2 Run
Not to take away from your thread bigcountry, but brucelanthier ran some numbers for my setup and he worked with me and we made a few minor changes to my setup and my bow has never shot as good as it is now. Just a public thanks to brucelanthier and my thanks goes out.