Going aluminum and need help...
#1
Going aluminum and need help...
I spent quite a bit of time looking at various arrows, point weights, and fletching options on my On Target! software for a heavier arrow that's properly spined. The only realistic option I have, it seems, are aluminum arrows. The carbon options are way too stiff, at least according to the program. My issue is which aluminum size to choose. I'm trying to get 380-440grains total weight with a 25" shaft (will go 26" if need be) and 125 grain tips and 4" feather fletch. My setup is 52lbs (56lb bow was sold), 25" drawlength, Parker Buckshot is the bow, and will probably use 2 bladed Magnus Stingers or Steelforce. Thanks in advance
#3
RE: Going aluminum and need help...
Not that there is anything wrong w/ aluminum, but there are heavy carbons out there. A beman Black Max 400 weighs in at just over 11 gpi, which in finished arrow weight would be in the 390's -low 400's.......
To be honest, I'm not sure what aluminum to use that would work.....You don't need a really stiff arrow, in fact the 400's are probably a bit overkill......Maybe a 2213 would be in there......I'll have to check out the weight on those......
To be honest, I'm not sure what aluminum to use that would work.....You don't need a really stiff arrow, in fact the 400's are probably a bit overkill......Maybe a 2213 would be in there......I'll have to check out the weight on those......
#5
Giant Nontypical
Join Date: Feb 2003
Posts: 9,175
RE: Going aluminum and need help...
1916 or 2013 will work fine for you. Only problem I can think of with them is, when you get into those sizes durability becomes a serious issue. You'd probably be better off going with a heavy carbon or composite arrow like the Black Max or Terminator Lite. The weight will be very comparable between these two and the aluminums, right around 400 grains.
#6
RE: Going aluminum and need help...
Just ran the Black Max's thru my program. If I go 26" with feathers and a 125 grain tip, the spine will be a little stiff. FOC about 14.4%. This is definitely one to consider. Thanx guys.
#8
RE: Going aluminum and need help...
Alright, I found some errors I was making in the software program. Those errors were probably why I was getting shaft selections like 2016's and 2114's and everyone else has 2013's. It's good practice to double check your work.
#9
Join Date: Feb 2003
Location:
Posts: 2,413
RE: Going aluminum and need help...
The only realistic option I have, it seems, are aluminum arrows. The carbon options are way too stiff, at least according to the program.
For instance, take a gold tip 3555 and add a 50 grain insert weight with your 125 gr head. You can fine tune the arrow length and/or draw weight to get it working perfect. It would be approx 400 gr and 19% FOC. This is just one example. There are dozens of other carbons that will work also.
#10
Join Date: Feb 2003
Location:
Posts: 2,413
RE: Going aluminum and need help...
Just to add....
If you want an even heavier arrow, you can go to the 5575s and add even more tip weight, to end up with an even higher FOC and total arrow weight. In this instance, you'd have to use a longer arrow also.
If you want an even heavier arrow, you can go to the 5575s and add even more tip weight, to end up with an even higher FOC and total arrow weight. In this instance, you'd have to use a longer arrow also.