X-Force , Target and 3D bow ????
10-25-2008 | 04:52 PM
#1
Thread Starter
Nontypical Buck
Joined: Jul 2007
Posts: 1,089
Likes: 0
From: England , UK
X-Force , Target and 3D bow ????
I was wondering if anybody hear uses an X-Force for target or 3D , if so what set-up are you using , sight , rest stabiliser etc ... any help would be helpful . Pictures are better
10-25-2008 | 08:10 PM
#2
Giant Nontypical
Joined: Dec 2005
Posts: 5,673
Likes: 0
From: Northeast Tennessee
RE: X-Force , Target and 3D bow ????
I was using my Mossy Oak X towards the end of 3D season and shot it VERY well in the Open class. I won a few and put up some really big numbers with it.
10-26-2008 | 03:54 AM
#3
Thread Starter
Nontypical Buck
Joined: Jul 2007
Posts: 1,089
Likes: 0
From: England , UK
RE: X-Force , Target and 3D bow ????
Sweet looking Bow Matt , what sight you got on their and what draw weight you pulling out of curiocity ? .
I see you are using the limb/driver , same as me . What length stabiliser is ok , or is it down to personal preferance ? .
I see you are using the limb/driver , same as me . What length stabiliser is ok , or is it down to personal preferance ? .
10-26-2008 | 09:59 AM
#4
Giant Nontypical
Joined: Dec 2005
Posts: 5,673
Likes: 0
From: Northeast Tennessee
RE: X-Force , Target and 3D bow ????
Well, I was drawing #52. That was a little too light for me but I had to have it that low so it wasn't too fast. I had my arrows built for my Shark X. The sight is a CBE Quad Lite 3D, and a CBE scope. They are probably the best target sight out there. They're pretty nice. The only reason I had a limbdriver on there is because it's my hunting rest and that's what this bow was for. Otherwise, I would have had a Spring Steel on there. The stabilizer is a Vibracheck CFX Carbon Freestyle 24". It's a good size for 3D.
