RE: 300wsm reloading problems
 

Any budies that you could borrow a set from to compare or even drag them to a local supply store

Mike

RE: 300wsm reloading problems
 

im the only one around here that owns one that i know of. The local supply store has none. Same reason, im the only one that has one. So i cant do either of those things, beleive me if i could i would have already done it.

[Deleted]
 

[Deleted by Admins]

RE: 300wsm reloading problems
 

yes i have done every thing you have said, and still no luck. I have lubed every thing that could be lubed and more. The cases were fired out of my gun. They are nickel plated. Does this make any differnce? Winchester fatory rounds.

RE: 300wsm reloading problems
 

It's darn hard to tell without being there but something maybe out of spec with either the dies or the brass. Since this is a new cartridge Hornady could have done something wrong or the brass may be thick in the neck or even too soft. I know a few people that have not been happy with different lots of Winchester brass in various calibers. Plus I have three sets of reloading dies from Hornady that work fine, BUT they are different to adjust than RCBS or Lee dies.

[Deleted]
 

[Deleted by Admins]

RE: 300wsm reloading problems
 

I think i need to send them back to the factory. Maybe they will fix them, very doubtful.

RE: 300wsm reloading problems
 

eyeball, try smoking up one of your unloaded cases with a candle or a disposable lighter, then drop it in your chamber and close the bolt on it. That should show you where the trouble is and maybe you can figure out what is going on with that die.

RE: 300wsm reloading problems
 

wonder if the nickle platting could be making the neck not resize properly. is the thickness of a plated case thicker than just a standered one.
Just grasping for straws at this point.
Mike

RE: 300wsm reloading problems
 

eyeball
can you get your hands on a few brass cases from a friend or some one and duplicate the exact same problem
problem ?

Mike