Whos gonna try it? 200fps gain in a 6xc...

Is the burn rate between 15 and 19?

If so I could like it for a .243 AI, and 19 in my 30-06 is a touch compressed. 17 there, might work a little better too.

Not sure, its suppose to be about the same as H4831 though.

According to what is on the Alliant site it should be great for the 308 based rounds.

IF it is about the same quickness as H4831, it would be about the same as RE 22, so it would be out of sequence in the Alliant RE number series.....

Since RE 19 is close to IMR 4350, I would expect an Alliant powder numbered RE 17 to be closer to IMR 4320 or H380. However, according to the information I have been able to find so far, it is closer to being between IMR 4350 and IMR 4831. This new powder is really something new, apparently, because it has a burn-controlling chemical that is throught the grains, not just a surface coating. The stuff is made in Switzerland, and apparently the grains are so compact you can get a lot more of it into a cartridge and still seat a bullet, as compared to some of the other, large-grain, slow powders.

Sounds like it might work well in rounds like the 6mm Rem & 7X57mm, as well as the short-action magnums! Guess I'll have to try some in my 6.5X54mm Mannlicher-Schoenauer as well as the 7X57mm.

Heres a good write up of it.

http://www.6mmbr.com/reloder17.html

Sounds very promising. Good luck.

I am excited to try this in my 06. I am holding off on a new big game gun until I see how it performs.If this can add 150fps to my 06 I am going to stick with my 06 for elk hunting out west.