Brass Question
#1
Nontypical Buck
Thread Starter
Join Date: Feb 2003
Location: NC
Posts: 1,284
Brass Question
I have about 30 bullets that i loaded for my 30.06 that i want to pull. This is virgin Rem brass and i use a kinetic type hammer puller. Before loading these bullets i checked the oal which was ok then ran the expander ball in the neck to get out any dents and then deburred. It's been a while since i pulled any bullets and i honestly can't remember if i did anything to the brass before loading it again after i did. Man i must be getting old or something, been having way to many brain farts lately.
After i pull these bullets do i need to do anything to the brass or can i just load up more bullets? Looks like the bullets would be a little loose. Thanks! Mike
[/align]
After i pull these bullets do i need to do anything to the brass or can i just load up more bullets? Looks like the bullets would be a little loose. Thanks! Mike
[/align]
#3
RE: Brass Question
ORIGINAL: bigcountry
At this point, I resize the necks again. You can try a few to see if you have enough neck tension. If you were close to max brass OAL, you might have to trim after sizing again. Thats about it.
At this point, I resize the necks again. You can try a few to see if you have enough neck tension. If you were close to max brass OAL, you might have to trim after sizing again. Thats about it.
#4
Nontypical Buck
Thread Starter
Join Date: Feb 2003
Location: NC
Posts: 1,284
RE: Brass Question
I pulled the bullets last night and then checked 10 of the cases for neck tension. Some felt ok and some didn't so i just went ahead and neck sized them all. OAL was fine so no triming was needed. Much thanks for the feedback. Mike
Thread
Thread Starter
Forum
Replies
Last Post
Duckbutter48
Reloading
1
04-19-2006 08:38 PM