Wasn't sure where to post this but here goes. Looking for a quality scope leveling (bubble level) system & also a quality inch/lbs. torque wrench, both for mounting scopes. Thanks!

This torque wrench works well:

http://www.midwayusa.com/product/718...ProductFinding

There are a number of levels around and I do not know if any one works better than the next. Tiny little bubble levels can only show if any surface is close to square with another surface with a tiny little bubble level on it.

I have read the comment on the internet that "my scope is bad due to cross hairs that are canted by one degree" from fellows that place way too much faith in their ability to center a bubble.

Here is another:

http://swfa.com/Borka-Tools-Precisio...5K-P60544.aspx

Wheeler has you covered.

I bought mine as 3 different tool sets, but they're available as a single kit now also:

Wheeler Alignment and Lapping kit
Wheeler Level-Level-Level Kit
Wheeler Fat Wrench kit

The single kit is on sale at Midway right now:

MidwayUSA WheelerScope Mounting Combo Kit