Ziess 3-9x50 wind age issue
12-07-2014 | 10:42 AM
#1
Thread Starter
Spike
Joined: Dec 2014
Posts: 1
Likes: 0
From: New Iberia louisiana
Ziess 3-9x50 wind age issue
Just purchased a new Ziess 3-9x50 Conquest with Z-Plex reticle but will not zero left to right. Still 1" off needs to go left but is bottomed out. Any help would be appreciated. Mounted on a 7mm Mag BAR
12-07-2014 | 11:30 AM
#3
Giant Nontypical
Joined: Dec 2007
Posts: 5,130
Likes: 0
From:
Before mounting the scope, count the "clicks" left to right - - set in the middle; then mount the scope.
That way you have the full "range" of "clicks" in either direction.
That way you have the full "range" of "clicks" in either direction.
Last edited by Sheridan; 12-07-2014 at 01:31 PM.
12-07-2014 | 01:18 PM
#4
Nontypical Buck
Joined: Feb 2003
Posts: 3,818
Likes: 1
From: Eastern wv
easier way! turn to lowest power, stick scope against a mirror and look through it, you'll see the reticle and a reflection of it, turn the knobs till the reflection is directly behind and lined up with the reticle, the scope is now mechanicly centered.
RR
RR
12-07-2014 | 01:42 PM
#6
Nontypical Buck
Joined: Feb 2003
Posts: 3,818
Likes: 1
From: Eastern wv
yep, most likely a flaw in the rings or the receiver is drilled crooked, a set of millette windage adjustable rings will fix it
center the scope install the rings, mount the scope, when bore sighting use the windage adjustment in the rings to get it as close as possible, then fine tune the zero with the turret adjustments.
RR
center the scope install the rings, mount the scope, when bore sighting use the windage adjustment in the rings to get it as close as possible, then fine tune the zero with the turret adjustments.
RR
