Custom Knife on Spalted Pecan
02-09-2020 | 10:59 AM
#1
Thread Starter
Boone & Crockett
Joined: May 2005
Posts: 12,563
Likes: 0
From: Burleson Texas
Custom Knife on Spalted Pecan
This is my model # 121 8 1/2 OAL with 3 1/4 cutting edge 3/16th thick. High Carbon Steel with satin finish and hollow ground. Tempered to 60 hrc for edge retention. On this one I used stabilized spalted pecan with black liners and custom file work on spine. The sheath is 9 oz veg tan leather double stitched and custom sprayed.
The edge geometry to work, the edge is not going to chip or roll with chopping through the pelvic bone.
Member of TEXAS KNIFE MAKERS GUILD
$ 230.00 TYD, Personal Check, Paypal or Venmo.
The edge geometry to work, the edge is not going to chip or roll with chopping through the pelvic bone.
Member of TEXAS KNIFE MAKERS GUILD
$ 230.00 TYD, Personal Check, Paypal or Venmo.
Last edited by The Rev; 02-09-2020 at 11:07 AM.
