Mossberg 535 Rust bleeding through camo
#1
Fork Horn
Thread Starter
Join Date: Feb 2003
Location: SW Virginia
Posts: 353
Mossberg 535 Rust bleeding through camo
We have a Mossberg 535 2-barrel set and rust is bleeding through the camo film of both barrels in at least a dozen places. There is no rust bleed through on the magazine tube, which I believe is also steel. This gun has never been abused. I intend to contact Mossberg after turkey season. I just wondered if anyone has had a similar experience.
#4
Typical Buck
Join Date: Feb 2004
Location:
Posts: 809
RE: Mossberg 535 Rust bleeding through camo
What you have is a gun that did not receive a proper rinse/and or treatmentafter the salt/and or camo edjing solution was applied.
And it will never quit![:@]
Contact the factory to get it replaced.
I had a Remington parkerized 742 do the same thing and I tried every solution I know of and it would not quit bleeding through. Remington finally replaced the whole gun, because of it.
And it will never quit![:@]
Contact the factory to get it replaced.
I had a Remington parkerized 742 do the same thing and I tried every solution I know of and it would not quit bleeding through. Remington finally replaced the whole gun, because of it.
#7
Did you happen to get blood on the barrel and miss it when you wiped the gun down? Ive seen missed blood cause this issue. I have one spot on my Winchester that was missed when i wiped the gun down after I shot a bird with it a couple years ago. Stupid me....
Thread
Thread Starter
Forum
Replies
Last Post
Tony Orlando and Dawn
Guns
1
05-02-2007 12:59 PM