View Poll Results: A poll
Voters: 24. You may not vote on this poll
Rifle build,which caliber?
#11
Join Date: Feb 2003
Location: va USA
Posts: 580
RE: Rifle build,which caliber?
If you're going to have a rifle built then it's obvious to me that the STW is the only choice.
Why invest the time and money in building a 7mm Rem Mag or 300 Win Mag when is so easy to buy one at any gun shop.
Why invest the time and money in building a 7mm Rem Mag or 300 Win Mag when is so easy to buy one at any gun shop.
#15
Thread Starter
Join Date: Feb 2003
Location: Walker LA USA
Posts: 443
RE: Rifle build,which caliber?
Ridge runner, what's the scoop on the 200 gr wildcat load????
The only question I have about the stw is brass availability for reloading,I hear winchester is no lomger making it.I guess you can allways neck down 8 mag cases.
CB
The only question I have about the stw is brass availability for reloading,I hear winchester is no lomger making it.I guess you can allways neck down 8 mag cases.
CB
#16
Typical Buck
Join Date: Feb 2003
Location: Greensboro NC USA
Posts: 563
RE: Rifle build,which caliber?
ORIGINAL: popeye
If you're going to have a rifle built then it's obvious to me that the STW is the only choice.
Why invest the time and money in building a 7mm Rem Mag or 300 Win Mag when is so easy to buy one at any gun shop.
If you're going to have a rifle built then it's obvious to me that the STW is the only choice.
Why invest the time and money in building a 7mm Rem Mag or 300 Win Mag when is so easy to buy one at any gun shop.
ORIGINAL: Doe Dumper
STW!! A ballistic chart reader's wet dream!
STW!! A ballistic chart reader's wet dream!
ORIGINAL: Ridge Runner
load that STW with 200 gr wildcats at 3100 fps and it'll put a spankin on the 300 winny.
I have an STW, had it built in '96, with good bullets it'll do whatever a 30 will do. with 140's it'll pulverize whitetails to 600 yds, with 160 accubonds its great elk medicine, with the 200 gr wildcat at 3100 fps, (BC of .85+ at 4500 ft.) its a 1K dream.
load that STW with 200 gr wildcats at 3100 fps and it'll put a spankin on the 300 winny.
I have an STW, had it built in '96, with good bullets it'll do whatever a 30 will do. with 140's it'll pulverize whitetails to 600 yds, with 160 accubonds its great elk medicine, with the 200 gr wildcat at 3100 fps, (BC of .85+ at 4500 ft.) its a 1K dream.
With a 1:10 twist you may get tad betteraccuracy with the 140gr's, the accuracy with the 200gr's would be tad worse, and optimum accuracry with the 160gr's-175gr's.
With a 1:12 twist, you get optimum accuracy with 140gr's,fair accuracy with 160gr's, and basically wasting your time with 200gr's.
What kind of twist are you shooting in your rifle to get such great accuracy out of such a wide variety of bullet weights??
#17
Typical Buck
Join Date: Feb 2003
Location: Greensboro NC USA
Posts: 563
RE: Rifle build,which caliber?
My stock Rem. M700 7mm RUM runs 140gr Ballistic Tip at an honest 3,674 FPS and160gr AccuBounds at an honest 3,527 FPS. Hardly twins at all. Never tried anything heavier than 160gr, because I still haven't seen any need to.
Also, the brass is a non-factor, unless you want to shoot competition, where you must squeeze every .001" of accuracy out of a gun and load.A 1/4"or less ain't going to make or break a big game rifile and load.
Also, the brass is a non-factor, unless you want to shoot competition, where you must squeeze every .001" of accuracy out of a gun and load.A 1/4"or less ain't going to make or break a big game rifile and load.
#18
Typical Buck
Join Date: Feb 2003
Location: Greensboro NC USA
Posts: 563
RE: Rifle build,which caliber?
Ordered 200 rounds of brass (same lot #), sorted cases by weight, trimmed & turned necks, uniformed flash holes, annealed, etc. Ended up with 71 rounds of matched brass and have the others segragated into 2 other batches. On the third reloading with these cases, haven't had any problems yet with split necks, swelled primer pockets, or head case separations, etc.
Yep Remingotn brass is not my first choice of brass for any of my rifles, especially in my wildcats, but in this case it was the only brass available in 7mm RUM. Not trying to convince you of anything. Been reloading for far tolong, withmany hundreds of thousands of rounds reloaded myself, for that.
Yep Remingotn brass is not my first choice of brass for any of my rifles, especially in my wildcats, but in this case it was the only brass available in 7mm RUM. Not trying to convince you of anything. Been reloading for far tolong, withmany hundreds of thousands of rounds reloaded myself, for that.
#19
Typical Buck
Join Date: Feb 2003
Location: Greensboro NC USA
Posts: 563
RE: Rifle build,which caliber?
No, never used it. You get that from Hi-Tech Ammo??I have gotten some powder from them in the past.About 10 years ago I bought a 4# jug of SRB-118 (I think it was). I used it to work a load with the 175gr Sierra MK HPBT in my .308 Wintacticall rifle. I was amazed when the chronograph lit up at over 2,900 FPS when we got higher charges, with no pressure signs, and sub- 3/4 MOA accuracy.
For my 7MM RUM, I use Accurate Arms 8700. With the 140gr B-Tips my load is 115 grains. With the 160gr AccuBonds, my load is 111 grains. One thing to note is, that I do not seat the bullets to feed thru the magazine. I use it as a single shot, so I seat the bullets so they are .0005" off the lands, and when seated that far out they will not fit into the magazine, but it allows me to get acouple extra grains of powder in the case.
For my 7MM RUM, I use Accurate Arms 8700. With the 140gr B-Tips my load is 115 grains. With the 160gr AccuBonds, my load is 111 grains. One thing to note is, that I do not seat the bullets to feed thru the magazine. I use it as a single shot, so I seat the bullets so they are .0005" off the lands, and when seated that far out they will not fit into the magazine, but it allows me to get acouple extra grains of powder in the case.