Hornday 7mm Interbond or SST??
11-03-2005 | 03:08 PM
#1
Thread Starter
Joined: Nov 2005
Posts: 1
Likes: 0
Hornday 7mm Interbond or SST??
I shoot hornady 139 ammo. what is the difference in the interbond heavy mag moly and the sst heavy mag molly. The ballistics are the same, so whats the difference in the bullet. Also, I want the rifle to hit dead zero at 300 yds, so where should it hit at 100 yds? On hornady's ballistic charts it hits dead zero at 200 yds. I use it to hunt deer in north alabama.
Thanks
Thanks
11-03-2005 | 03:35 PM
#2
Giant Nontypical
Joined: Feb 2003
Posts: 5,667
Likes: 0
From: fort mcmurray alberta canada
RE: Hornday 7mm Interbond or SST??
The interbond bullet has the core bonded to the jacket so it holds together better than the sst.That provides better penetration and weight retension.
11-03-2005 | 06:38 PM
#4
Fork Horn
Joined: Dec 2003
Posts: 395
Likes: 0
From: New Mexico
RE: Hornday 7mm Interbond or SST??
The # 1 I had loved the heavier 175 gr. bullets, as well as the Encore that I own now. I load all of my rounds.
175 gr. Horn. Inter.
65 gr. of RL22
Fed. Cases
CCI Primers.
Works perfectly in my rifles.
NOT RESPONSABLE FOR ANY LOADS THAT WORK FOR ME.
hunter338
175 gr. Horn. Inter.
65 gr. of RL22
Fed. Cases
CCI Primers.
Works perfectly in my rifles.
NOT RESPONSABLE FOR ANY LOADS THAT WORK FOR ME.
hunter338
11-03-2005 | 07:10 PM
#5
Boone & Crockett
Joined: Feb 2003
Posts: 10,679
Likes: 0
RE: Hornday 7mm Interbond or SST??
From the outside they are almost identacle. But on the inside is where they are really different.
The SST is a conventional boat tail bullet with a plastic tip. The jacket is relatively thin and gradually thickens toward its base. It is not bonded in any way and at higher velocities the jacket and core can seaperate.
The interbond is a chemically bonded bullet with a plastic tip. The jacket starts out thin in order to initiate expansion then rapidly thickens to control the depth of expansion. The jacket is bonded to the lead core and even at very high velocities the jacket will remain intact with the core and will retain far more weight thanthe SST.
Here are the two side by side so you can get a look at the differances. The SST is on the right and the interbond on the left.
The SST is a conventional boat tail bullet with a plastic tip. The jacket is relatively thin and gradually thickens toward its base. It is not bonded in any way and at higher velocities the jacket and core can seaperate.
The interbond is a chemically bonded bullet with a plastic tip. The jacket starts out thin in order to initiate expansion then rapidly thickens to control the depth of expansion. The jacket is bonded to the lead core and even at very high velocities the jacket will remain intact with the core and will retain far more weight thanthe SST.
Here are the two side by side so you can get a look at the differances. The SST is on the right and the interbond on the left.
11-07-2005 | 04:38 PM
#6
Joined: Oct 2005
Posts: 6
Likes: 0
RE: Hornday 7mm Interbond or SST??
For several years I have used hornady BTSP 139 gr in my 7 mag. Never had a whitetail take a step after being shot. I decided to try the SST this year. I shot a doe in the chest last week with the new SST. The deer was at about 70 yds. The doe ran about a hundred yards. When I was cleaning it fragments of the SST were everywhere. Next weekend I am going to carry the Hornady BTSP with me. Some people say they love the SST while others hate them. I hate them. At a lower velocity they might be fine. But with a 7 mag be careful. Just my experience.
