Excal Models
06-29-2008 | 06:23 AM
#1
Thread Starter
Nontypical Buck
Joined: Nov 2004
Posts: 3,048
Likes: 0
From: Land of Rocks, Ozarks of Mo.
Excal Models
i won't go into the old ones with wood stocks, nor the thumb hole stock models. the thumb holes will not interchange stocks! all others are covered here, vixen-exocet & 200- phoenix-exomag & max.
they all use the same limbs and all parts interchange. be it flat cast riser or machined forward risers. all limbs can be swapped but carved tip must use dacron strings! rails power stroke come in lengths of in inchs as follows. 13 1/2 14 14 1/2 15 15 1/2 16. all rails trigger assbly scope mounts risers will interchange!
you can have a vixen to exomax by just the rail change!
DNK thought this info would be useful and he said it should be posted. so this is a co-op'ed post topic by us! thank you for letting us share with you folks[8D]
i had to correct my mistake its power stroke of the rails
]
they all use the same limbs and all parts interchange. be it flat cast riser or machined forward risers. all limbs can be swapped but carved tip must use dacron strings! rails power stroke come in lengths of in inchs as follows. 13 1/2 14 14 1/2 15 15 1/2 16. all rails trigger assbly scope mounts risers will interchange!
you can have a vixen to exomax by just the rail change!
DNK thought this info would be useful and he said it should be posted. so this is a co-op'ed post topic by us! thank you for letting us share with you folks[8D]i had to correct my mistake its power stroke of the rails![
]
07-03-2008 | 12:40 PM
#3
Thread Starter
Nontypical Buck
Joined: Nov 2004
Posts: 3,048
Likes: 0
From: Land of Rocks, Ozarks of Mo.
RE: Excal Models
i have had several ppl on excal tell me that the forward riser and the staight riser will not interchage![]Said the machined flat was too narrow on machined riser. Hog slop![8D]
I just took both of mine completely apart, cept the trigger assbly. and they interchange completely. i sat here for 2 hrs changing stocks, trigger assbly. rails, risers, limbs and all the bolts and screws.
]Said the machined flat was too narrow on machined riser. Hog slop![8D]I just took both of mine completely apart, cept the trigger assbly. and they interchange completely. i sat here for 2 hrs changing stocks, trigger assbly. rails, risers, limbs and all the bolts and screws.
