Dan,
I can't tell by the pic. how the foam holds the arrow. does it just set on it? is it tacky? does it grab the arrow? what if you tip the bow?
I like the looks of it. It looks like it would be real quiet.
cost?

The arrows just fit in fairly snug. There is no tackiness to them. I can turn my bowhandle level with the ground and the arrow stays put, past that it will dump out, but I never even hold the bow handle level with the ground so it's not an issue for me. They are less than $7 including shipping.

Dan

I use the NAP arrow holder and absolutely love it. I couldn't imagine shooting a dropaway without one. It holds the arrow tight enough to prevent it from coming off the riser even when the bow is sideways or upside down, and pops out without a problem when the bow is drawn back. I hunted with it in temps down into the single digits and never had a problem at all. I cut out a small section of the mole skin on my riser to allow it to attached directly to the riser via an adhesive backing and it's been on there for three years now without a problem. I believe you can pick them up through Bass Pro or Cabela's online.

Yep, libmdriver provides the NAP or an equivalent (Looks the exact same). They work great. I can turn my bow sideways, upside downs and any way I want and arrow stays put. Then when I draw my bow it doesn't violently pop out or anything just a nice smooth transition.

i had one on my bow it worked great until last season as i was pulling the bow into the stand it caught on somthing and pulled it off. it landed some where on the forest floor. never found it . I need to get a new one to put on my bow

I must say, i like the wraps.

Thanks Brian!!

Dan