DR KILL

OK I JUST GOT MY TROPHY RIDGE GUIDE SERIES REST SETUP YESTERDAY, NOW THE PROBLEM IS EVERYTIME I DRAW THE BOW THE ARROW DOES NOT SIT ON THE REST ,INFACT IT RISES AND SETS ON THE INSIDE OF THE RISER AND I HAVE TO USE MY HAND TO GET THE ARROW ON THE REST,,,,, NOW IF I PUT MY RELEASE UNDER MY STRING LOOP (KNOCK) THE BOW DRAWS PERFECT, DO YOU THINK THE PROBLEM IS THAT THEY SET THE KNOCK TO HIGH OR LOW?? PLEASE ANY INFO IS WELCOME ,,, THANK YOU FOR YOUR RESPONSE

AlaninWI

Sounds to me like your nock may be getting pinched too hard causing the the arrow to rise and not touch the rest. Check your setup and make sure that is not happening. Alan

DR KILL

yup thats it, the dang knock is getting pinched

thanks guys for the quick reply and goodluck to ya

mrfritz44

I got rid of my string loop and switched over to an eliminator button setup with a tied in nock. The arrow stays put on my Drop Zone, and it's easier to attach the release to the string. IMO, it also affords a more positive and deliberate feel when attched directly to the string. Just another option you may want to consider.

PABowhntr

Another solution would be to tie-in two small nocksets with serving material above and below where your nock is on the string. This helps to alleviate the nock pinch problem to a large extent.