This might be a dumb question but I am going to start making my own arrows and I'm trying to minimalize the costs.
Anyone tried cutting arrows with a pipe cutter ?
I know they cut straight and square perfectly.


F.

I think it would work for aluminum arrows. I just use a hacksaw and square up the end with a manual .30 calibercase trimmer that I use for reloading my '06. Rifle case mouths must be perfectly square as well. Works great.

Dremmel

you can use a dremel tool to cut carbons? if so that means u should be able to use a bench grinder to cut carbons? or am i assuming too much?

I use a tubing cutter on aluminum arrows and it works well. I used to use a dremel on carbons but never could get a good square cut that I was happy with. I have since gotten a Harbour Frieght Mini Cut-Off saw for the carbons. BIG difference and it cost less than $30.

i was just thinking, HOW would u get a square cut with a dremel or anything like that, seems nearly impossible

go here to learn how to set up a demmel :

http://www.deerslayer.freewebspace.com/hbarrowsaw.html

thx Jamaltwy, looks like a guerrilla set up, but if it works, it works.....


Frank.

I'll post pics when I get my dremel.....

Yup great pics to show how its done.

Can't get the arrow square?

G5 ASD will fix that in very little time.