I'm currently using a Bohning jig (right helical) to install Blazers to my arrows and was wondering if anyone out there has tried the new jig from Bohning made special for Blazers. I'd like to know if it's worth the $40 or am I better off with my current set-up. Thanks in advance.

I didn't know that Bohning had a jib specifically for Blazers. I'm interested in it. Where can one find information about it?

Thanks...

http://store.bohning.com/products/2581.xml?cat=1740

Gracias Madjac!!

Looks Puuuuuuuuuuuuuuuuurdy.

I bought one and its a piece of junk! I'm sending it back. I couldn't get it adjusted to fletch some axis arrows, the rear of the blazer wouldn't touch the shaft. I've been fletching arrows for 12 years and never had this problem.

Based on the over-whelming responses this is about what I expected. I'll continue with my current set-up.
Thanks for the input.

There is a thread in this forum that talks about them.

Here is the URL, I hope!

http://www.huntingnet.com/forum/tm.aspx?m=2074557

Are you serious...that is this thread! LMAO

Well I did say "I hope". LMAO too!!! Big time!