An author of a web site devoted to black powder pistols recommended putting anti-seize on the nipple threadsof your cap 'n' ball revolver. I was wondering do any of you do that/recommend it?

Thanks,
~Robert

It wouldnt hurt to add a little to the threads. I add a bit to my nipples and vent liners on my rifles.

sounds kinky?!!!!!!!!! - Yes, I put anti-sieze on my nipples as well as my flash hole.

I always use antiseize on my breach plugs, nipples and clean out screws. It's a little messy but is far better than a stuck plug, nipple or screw.

Now Bronko, I have to wonder about that flash hole thing. Is that a medical neccessity?

Just kidding, it's a good idea.

Yes I use it. The easy way to apply it is with a tooth pick. Tom.

OK, thanks all!

RobertSubnet

I do put anti-sieze on the nipple PART that goes into the breech plug or the bolster - just to be clear... before SEMISANE gets here...

i use a q-tip and spin the threads around it. a little goes a long way.

Ditto

I use a model builders paint brush and just paint a light coat on all the nipples I install in my muzzleloaders and revolvers. It makes them come back out a lot easier...