I have an 03 mighty mite, initially the bow was setup by the shop with the nock high 1/4" +or-, the bow would not tune until the nock was placed 1/8"+ low. the bow now shoot bullet holes with feathers or bare shafts from 6 ft to about 10yards (which is where i stopped shooting through paper) This seems totally wrong. I am shooting through a whisker biscuit using a release. Also I initially tried to set the bow up with turbo nocks. I would really like to use these if they could fly a broadhead true. With the nock high the turbo nocks flew through the rest fine but caused a nock high tear. With the nock lowered to the new setting which causes bullet holes with feathers and bare shafts, the turbo nock contacts the bottom of the biscuit causing the lower plastic fletch to be sheared off. Has anyone had any similar experiences with either the nocking point or tuning issues with the turbo nock.