OK, I know I’ve been saying this a lot, but I for sure found the problem this time. I can’t believe it was this simple.

It all roots back to when I first built the gun from the kit. Once I built it, I tried shooting it immediately. However, I failed to align the open sight.

I figured this out, because there was no wind today and I shot a target at 25 yards. All my shots were about 2 inches to the left of the bull’s-eye, even though I was aiming at the bull’s-eye. I adjusted the site appropriately, and had good results at 25 yards, so I went to 100 yards. After four shots at 100 yards, I realized I fixed the problem. Every shot was getting into the kill zone at 25 yards and 100 yards.

I fixed it, and I’m very happy right now. Thank you all for the help and the advice.

Jared