Does that bow have a split yoke that is part of the string or does the yoke go through a loop in the cable. Either way try to measure the length of the cable with a tape measure. A soft tape used for sizing pants and shirts works best. This should give you a real close idea as to what length you need. If your cable is broken that is a different story. I just built a cable for a friends old jennings and it was about 2 inches longer than his axle to axle length. I am asuming this is a single cam bow as the cables for them has not changed much over the years. Even Hoyt buss cables are similar on their cam and a half bows. Have you tried looking on the Bear web site for your bow under the tune chart section or specs section. I hope this was some help. o you build your own strings or are you just looking to order one from some one?