OK I took the barrel out and cleaned it all up then put it back into the stock. But I still had a little wobble to the barrel so I ground a section of the channel between the wedge pin area and the fore end tip (about 1 1/2") and mixed another batch of epoxy. I put some tape over the top of the stock and molding clay in front and back of the bedding area. After waxing the barrel I applied the epoxy and reinstalled the barrel. This was quick set epoxy so after 2 hours I took the barrel out and cleaned it up as well as the barrel channel. Reinstalling the barrel and it fits perfectly. Not a smidgen of wobble at all.