I just purchased a CAM & 1/2 Cybertech and when I zero out the weight (crank it all the way up) so I can index(turn the bolt the exact same amount) the weight bolts. The tiller measurement is between a 1/8 to a 1/4 of an inch different,
but if I turn the out the affected limb about a 1/4 of an inch the tiller is right on. ? is it ok for the weight adjust ment bolts to be a little off, not exactly the same amount of turns? Is the top tiller measure ment supposed to be the exact same as the bottom tiller measurement? Or should there be a slight offset Any advice or help would be greatly appretiated.

Thank you
Corey