Reloading for a Rem 7600
I just started reloading for a pump 7600 in 30-06. I full length resized with Hornaday dies and the rounds tend to chamber tight in the chamber. The cases I used had been fired in a bolt action rifle. They also where trimmed .010 shorter than max length. The rifle must have a short throat, I used the same OAL as a bolt action and when I tried to chamber the round, the bullet stuck in the barrel and had powder every where. I then made a dummey round and started seating it till around .010 off the lands. Can I just go get some new brass and start from fresh?