Thanks for the reply. I know my questions are elementary. I have read that I should put release agent all over the gun and action. I also read that I may want to practice with silly putty as my epoxy untill I get it down right and then use JB Weld or the epoxy that is included with the bedding kit when im ready. Is one better than the other? I guess I need to bed the trigger gaurd as well. Also, I know to ruff up the area where the bedding will go but do I need to remove any wood from the stock? How thick should the layer of bedding be? I am assuming that the barrel will be a tad higher and this will also lift the trigger since its attached to the barrel......so will this effect the trigger pull or finger placement? Sorry for all the questions, I figure that what I can learn by asking, the less I have to learn the hard way.